Change id not being accepted
The Change-id is by default configured to accept only specific formats.
A configuration file exists to modify the format, its character or add additional patterns.
Look at the "Change_id" section of the table at the bottom of this article.
Related Articles
Enable debug and creating support file
Debug mode is enabled when we need more logs to analyze any issue. In this article we shall enable debug for a Job. Debugging via GUI Enabling Debug (1) Admin -> System -> Debug Logs -> (2) Start debug -> (3) OK Create a Job Create ...
Setting up High Availability
In this article we would be setting up two instances of NetYCE that would act as Master-master relationship. Pre conditions It is assumed we already have cloned the primary server or set up a new one. If you have installed a new system (VM), make ...
Setting up LDAP authentication
In this article we will be seeing how to setup LDAP authetnication in NetYCE. We will be using below sample LDAP server details for the setup. LDAP Test server details LDAP Server Information: Server: ldap.test.com Port: 389 Bind DN: ...